Introduction
    AGWPE Overview
    More about AGWPE
1. Interface
    Getting Started
    Kits and Pre-assembled
    Receive Audio Cable
    Transmit Audio Cable
    PTT (TX Control) Cable
    2 Radio Modification
2. AGWPE Set Up
    Download and Install
    Basic AGWPE Setup
    2 Radio Setup
    2 Card Setup
3. Sound Card Setup
    Basic Settings
    Additional Settings
    Tuning Aid
4. Windows™ Setup
    TCP/IP Settings
    Update Windows
5. Problems?
    Program Behavior
    Receiving
    Transmitting
    Connections
6. Using AGWPE
    AGWPE on a Network
    Baud Rates & Modes
    Remote Control
    TCP/IP Over Radio
    Tips and Tricks
    Traffic Parameters
7. Compatible Programs:
    Setup Help
    UI-View
    WinAPRS
    Winpack
    Others
  
   

Update Windows

A. Windows 95, 98 and 2000 Users

• You will need the most recent version of the Window's "Common Controls". If you've installed Internet Explorer (IE) version 5.0 or later, then the controls should be installed.
  
  If you haven't upgraded to IE 5.0 or later -- or want to check that the controls are installed -- search for sites that offer "Comctl32.dll".  Here's one site.
  
• Also, make sure you have the most recent drivers for your sound card. You will need to visit the sound card manufacturer's web site to verify this.
   

B. Windows 95 Users only

• You must have the Winsock 2 update installed, otherwise the TCP/IP interface will not work correctly with AGWPE. Here's the correct order to do that (I hope):
  • First make sure you have the Dial-Up Networking (DUN) and the TCP/IP Protocol installed in Windows.
  • Download and install the DUN 1.3 Performance & Security upgrade.
  • Download and install the Winsock 2 update from the Microsoft web site.
  • Then go to the Microsoft web site to download and install the DUN 1.3 Networking and Winsock2 Year 2000 Update
    
    If you have any problems or get an error message during this process, see the Winsock 2 update release notes for information about what went wrong and how to correct it.